• 6LoWPAN compliant
  • Mesh network architecture
  • Scalable up to thousands of nodes
  • Leverages proven standards: IPv6, RoLL/RPL, 6LoWPAN, 802.15.4e, 802.15.4g, CoAP
  • CoRe/REST compliance
  • NIST-recommended link security

Nivis marries its open standards software stack with Freescale’s Kinetis radio module to provide a high quality radio node that can be incorporated into wide range of sensing and control devices.

Software Stack

Nivis offers its industry leading radio node software stack either bundled with the physical device or separately.

The Nivis implementation is IPv6 over Low power Wireless Personal Area Networks (6LoWPAN) compliant, insuring inter-operability with a large number of other hardware and software suppliers. Nivis employs IPv6 Routing Protocol for Lossy and Low-Power Networks (RPL), to drive down power requirements and maximize battery life.

+   Mesh network architecture ensures communications reliability by eliminating potential single points of failure
+   Leverages proven standards such as IPv6, RoLL/RPL, 6LoWPAN, 802.15.4e, 802.15.4g, CoAP to reduce cost and increase interoperability
+   6LoWPAN compliance, the de factor standard for low cost, power constrained devices, insures interoperability, reduces power use and extends battery life.
+   Enhanced RPL support increases reliability, reduces power consumption and improves network routing efficiency
+   NIST-recommended link security secures communications at the link level, mandatory for most applications
+   CoRe/REST compliance implements web services all the way to the node so that smart objects can be accessed from any browser
+   PHY support for 868 MHz band permits marketing and deployment in Europe.
+   Scalability (up to 3,000 devices per gateway at present) permits cost effective deployment of very large networks


The Freescale Kinetis-based hardware demonstrates exceptional RF performance with very low power requirements, along with support for a variety of modulation schemes and frequency bands.

+   RF Performance: Up to -120dBm sensitivity @ 1.2kbps, -105 dBm @38.4 Kbps. -18 to + 17dBm output in step of 1 dBm
+   Front end: IIP3 = -18 dBm, IIP2 = +35 dBm, 80 dB Blocking Immunity
+   Power: 100nA with radio configuration retention, 16 mA Rx current, 20 mA Tx current at 0 dBm and 33 mA Tx current at +10 dBm Supports run, sleep, and deep sleep modes, along with low leakage wake up unit
+   Standards Compliance: Support for multiple modulation schemes (GFSK, MSK, GMSK, and OOK) and frequency bands (290-340MHz, 424-510MHz, and 862-1020MHz)
+   Integration: Includes proven HCS08QE 8-bit MCU core with up to 50MHz bus clock, embedded 32KB Flash and 2KB of RAM supporting wireless communication protocol and application software in a single chip
+   Peripheral support: Multiple 16-bit timers, up to 33 GPIO. 13-bit port keyboard interrupt, 10 channel-12-bit ADC, SCI, I2C, and dual analog comparators
+   Security: Sophisticated encryption and anti-tampering features, including various access disable options, memory protection, tamper detection, cryptographic acceleration, secure storage and secure real time clock
+   System features: -40 to +85 degrees C operating temperature 1.8V to 3.6V RoHS compliant 8×8 mm 56 pin LGA

The solution operates in the USA, Canada, Europe, Japan, Korea Brazil and Mexico using FHSS spread spectrum and GFSK modulation. See specs for country by country frequency bands, data rates and channels.

Supply Voltage-0.3 to 3.8 Vdc
RF Output Level (Max)+15 dBm maximum @ antenna port
Input RF Level (Max)+6 dBm
Voltage on any digital I/O-0.3 to (VDDINT + 0.3)
Storage Temp Range-55 to 115 °C
Operating Temp Range-40 to 85 °C
Supply Voltage3.3 V nominal
Transmit current140 mA @ 17 dBm typical
Voltage on analog pins0 to Vcc V
Voltage supply noisemax 200 mVpp 50Hz - 15 MHz
Storage and operating temperature-40 to 85 °C
Operating relative humidity10 to 90 %RH non condensing
Receive current50 mA typical
Hibernate currentless than 10 µA typical
Input High-level Voltage (all digital inputs)70% Vcc to Vcc
Input Low Voltage (all digital inputs)0 to 20% Vcc Vdc
Output High-level Voltage (Imax = 1 mA) (All digital outputs)Vcc - 0.5 Vdc
Output Low Voltage (Imax = -1 mA) (All digital outputs)0 to 10% Vcc Vdc
Input hysteresis (all digital inputs)0.06 Vcc Vdc
Dimensions1.5" x 1" x 7/16" (LxWxH)
Operating frequenciesUS & Canada: 902-928 MHz; Japan: 922.3-928.1 MHz; Europe: 863-870 MHz
Number of channelsUS & Canada: 64/129 depending on data rate; Japan: 28; Europe: 64
Channel spacingUS & Canada: 200/400 kHz; Japan: 400 to 600 kHz; Europe: 100 kHz
Frequency accuracy± 15 PPM (30 MHz reference crystal)
Data rateUS & Canada: 50/150/200 kbps; Japan: 50/100/200 kbps; Europe: 40 kbps
Receiver sensitivty-100 dBm @ 50kbps; -90 dBm @ 100kbps; -94 dBm @ 150kbps; -92 dBm @ 200kbps
Output power range902-928 MHz, -20 to +15 dBm; 922.3 -928.1 MHz, -20 to +11 dBm; 863-870 MHz, -20 to +12 dBm
RangeUS & Canada: 1.2 mile line of sight; Japan: 1.6Km line of sight; Europe: 1.1 Km line of sight
Impedance50 Ω
Gain+2.2 dBi
Maximum VSWR2:1
ConnectorMMCX connector, right angle on cable
EMC CanadaIC
EMC EuropeETSI EN 300 220-1, ETSI EN 300 220-2
EMC JapanGiteki